Crystal Vision
Installation
Indigo 2 CoolFlow User Manual R1.3
18
20/06/2012
Setting up and connecting
The frame can be connected to a network port or directly to a PC from the rear panel RJ45
port labelled Ethernet. If connecting directly to a PC, a CAT-5 cross over cable will be
required. Connecting to a network port hub uses a straight CAT-5 cable.
To access the internal web page set the frame to the default IP address by setting the default
IP address switch DIP4 to down. Open up your PC web browser and set its search to
http://10.0.0.201 and select ‘go to’. This is the default IP address, the sub-mask being
255.255.255.0. After a dialogue box has briefly appeared the Indigo main status page will be
displayed. This page will give a large amount of status information about the frame and its
power supplies. From the webpage several options are available such as changing the IP
address and frame naming.
Note:
Once the IP address has been changed the status page will be accessible via this new
address.
The Indigo Status page
