BA_Migros_ED3EX_GB 09.02.2011 12:13 Uhr Seite 21
Probedruck
C
M
Y
CM
MY
CY CMY
K
GB
Brake
The brake system must be checked before each ride. Only the
dealer should be entrusted with the job of adjusting the brakes.
Readjustment of the brakes is required when you observe an
increasing idle travel of the hand brake lever. The same comes
closer and closer to the handle bar grip due to the wear and
tear of the brake rubber (shoe). Regular readjustment is
necessary.
The brake rubbers are parts subjected to wear and tear and they
do not constitute a materials defect liability.
Rear wheel back pedal brake
This brake cannot be adjusted.Please note that the brake
becomes ineffective the moment the chain is damaged or comes
off.
Pedals
The pedals must be fixed tightly at all times. During assembly
and dismantling, please keep in mind that the pedals have two
types of threads. The threads on the pedals and the treadle are
exposed to strong forces. They hold only if the pedals are screwed
tightly.
The right pedal (chain side) is marked with R at the axle end
and has right-hand threads.
The left pedal is marked with L at the axle end and has left-
hand threads.
“Front-stem”
Figure 12
Figure 13
Foot pedals
The foot pedals are mounted with hexagon bolts on the square
attachments of the bottom bracket axle. The stable hub of the
foot pedal must be checked regularly. Remove the safety caps
and tighten the screws located below them.
The right pedal must
therefore be screwed in
the clockwise direction,
while the left pedal must
be screwed in the opposite
direction.
left-hand
thread
right-hand
thread
117
Pedelec with Lithium-ion battery
