BA_Migros_ED3EX_GB 09.02.2011 12:13 Uhr Seite 24
Probedruck
C
M
Y
CM
MY
CY CMY
K
Operation of the Pedelec Drive
For operation of the bike’s functions, please refer to Page 135
“General operation”.
The LCD instrument display to control the electrical auxiliary
actuator (Fig. 20) is located in the middle of the handlebars.
The ED-3EX Pedelec can be switched on and off using this panel
and the desired operation mode activated. The current status
of the battery, i.e. the remaining capacity, can be seen in a
five-stage LCD display on the right-hand side. The “consumption
display” is found on the left-hand side. The number of bars
indicates whether you are using the best consumption level.
In addition, speed and a clock are also displayed together with
basic bike computer displays.
Torque specifications
Axle nuts of front wheel
20 Nm
Axle nuts of rear wheel
25 Nm
Foot pedal mounting
30 Nm
Brake pad mounting
5 Nm
Dynamo mounting
10 Nm
Other screws:
M4
2,1 Nm
M5
4,2 Nm
M6
7,3 Nm
M8
17 Nm
M10
34 Nm
Rims
Rim wear indicator:
Many aluminium rims are equipped with a wear indicator.
Request your dealer to provide detailed information.
Chain tensioning
Ensure that the chain is tensioned correctly; it is the most
important part of the drive module. A regular check is necessary
since the chain stretches in course of time. If necessary get the
chain re-tensioned by the dealer.
As shown in Figure 18, it should be possible to slightly move
the chain up and down by approximately 1.5 cm at the centre
of the two sprockets.
CAUTION against rim wear!
Check the condition of your rims regularly. Please
contact your dealer in time.
RISK OF FALL AND ACCIDENT!
Figure 18
120
Operating instructions
ED-3 EX
