BA_Migros_ED3EX_GB 09.02.2011 12:13 Uhr Seite 6
Probedruck
C
M
Y
CM
MY
CY CMY
K
102
5)
Start pedalling. The motor is activated after a half-rotation of
the pedals.
6)
If you are riding this bicycle for the first time, please
try out the available operation modes in low-traffic
areas.
7)
The available operation modes are 1, 2, 3 and 4. The modes
1–3 restrict the max. operational power level. This facilitates
an increase in operating distance.
8)
At the end of the ride, shut off the system by pressing the
"ON/OFF“ button (l.)
9)
The CROSSWAVE Pedelec will take you home even on an empty
battery like an ordinary cycle.
The battery electronics prevents
an excessive discharge of the battery.
10)
Recharge the fully empty Lithium-ion battery after completing
the ride.
If the Lithium-ion battery is only partially empty,
continue to use it for subsequent rides till the battery is
completely empty.
11) If you do not use the battery for more than 6 month, recharge
it fully.
Enjoy your drive on the CROSSWAVE Pedelec!
Quick start
Even though you might be eager to use your newly purchased CROSSWAVE
Pedelec immediately, we request you to observe the following steps
without fail before taking your first ride. PanTerra™ will not accept
any guarantee obligations otherwise!
1)
Remove all the protective foils from the battery. Please check
the current charging status of your battery by pressing the key
on the LED display (refer to Page 14). The CROSSWAVE Pedelec
is powered by a Lithium-ion battery.
Now charge the battery fully first! Please use the original PanTerra™
Lithium-ion charging device only. Then insert the battery in the
luggage carrier holder and secure the lock (refer to Page 14).
2)
Adjust the handle bar and seat; check to ensure that the drive
and brakes function and that all screws, especially the wheel
nuts are properly fixed (refer to Page 17).
3)
Switch the system on at the left of the handle bar: Press the
switch to “I” on the control unit. The CROSSWAVE Pedelec is now
ready for a ride.
The electronic circuit however is deactivated
after approx. 8 min of inactivity in order to save energy!
If
this happens, switch off and then on again.
4)
By activating the four-mode panel, the energy-saving
modes 1–3 can be selected via the Assist button.
Operating instructions
ED-3 EX
