Cronyx FMUX/SAT, Installation And Operation Manual

Page: 17 / 44

© 2006 Cronyx
1
Section 2. Installation
SNMP Port Connector
RJ-45 female socket is used for connection of Ethernet cable (10Base-T, IEEE 802.3
standard) for management via SNMP protocol:
Fig. 6. SNMP port connector
Use direct cable for connection to hub.
Console Port Connector
The device may be managed using ASCII terminal (console). DB-9 (female) connector
is used for console connection. The console port has standard RS-232 DCE interface,
and utilizes the following settings: asynchronous mode, 9600 Baud speed, 8 bits/symbol,
1 stop bit, no parity.
An RTS signal (for flow control) from the console terminal is required for
proper operation.
It is recommended to use following cable diagrams:
Cable without modem control
GND 5
TXD 3
RXD 2
RTS 7
CTS 8
DTR 4
CD 1
GND
TXD
RXD
RTS
CTS
DTR
DSR
CD
GND 5
TXD 3
RXD 2
RTS 7
CTS 8
DTR 4
DSR 6
CD 1
GND
TXD
RXD
RTS
CTS
DTR
DSR
CD
Cable with modem control
Fig. 7. Console cable diagrams
Use direct cable for connection to PC COM port.