© 2022 All rights reserved. Data subject to change without notice.
27
Rev. C | 2022.02
FCS - Operation Manual
Enter the length of time you want to test the strobe for. Press Start Test to begin the test.
To cancel the test, go back into the Test menu, open the Test Strobe screen and enter 0 in the
Minutes field and press Start Test.
To cancel the test, go back into the Test menu, open the Test Strobe screen and enter 0 in the
Minutes field and press Start Test.
5.3 Test Relays
NOTE:
Before testing the relays, notify the appropriate people so unnecessary distress or
response is not caused.
In Test menu (passcode 1), press on Test Relays.
Enter the relay number you want to test and enter the length of time you want to test the
relay for. Press Start Test to begin the test.
To cancel the test, go back into the Test menu, open the Test Relays screen and enter 0 in the
Minutes field and press Start Test.
NOTE:
Relay ON and OFF delays do NOT apply in test mode.
5.4 Test Analog Outputs
The purpose of this test is to make sure the wiring is correct and the connected devices
operate as expected.
NOTE:
Before testing the analog outputs notify the appropriate people so unnecessary
distress or response is not caused.
In Test menu (passcode 1), press on Test Analog Output.