2. Press and hold the bottom button of the keypad until a set of lights in
the space starts to flash on and off (about 3 seconds). The flashing
lights indicate the selected load controller. The LED on the keypad
flashes to indicate that the load is bound or unbound.
l
The LED flashes quickly to indicate that the load controller is bound.
l
The LED flashes slowly to indicate that the load controller is not
bound.
NOTE:
The flashing rate of the lights does not indicate the link
status.
3. Press the bottom button of the keypad repeatedly to cycle through all
of the load controllers in the Zūm space until the desired load starts
flashing.
4. Press the top button of the keypad to assign the load controller as
bound or not bound to the keypad. The LED on the keypad flashes to
indicate that the load is bound or unbound.
l
The LED flashes quickly to indicate that the load controller is bound.
l
The LED flashes slowly to indicate that the load controller is not
bound.
NOTES:
l
If all load controllers in the Zūm space are assigned as not
bound to the keypad, the keypad will restore its default
functionality and all load controllers will become bound to the
keypad.
l
The flashing lights indicate the selected load controller, not the
binding status.
5. Repeat steps 3 and 4 until all load controllers are bound or unbound
from the keypad.
6. Press the bottom button on the keypad 3 times to exit Binding mode.
15
ZUMMESH-JBOX Series
Quick Start
Zūm™ Mesh Wireless J-Box Load Controllers
