QuickMedia™ Receiver
Crestron
QM-RX
QM Network Wiring
For the QuickMedia transport, use CRESCAT-QM.
The aggregate cable length from transmitter to receiver cannot have a delay
skew of more than 22 ns for a given signal path originating at a QM transmitter
and terminating at a QM receiver. The aggregate cable length must not exceed
328 feet.
When connecting multiple QM devices, the route between a QM origination
point (transmitter) and a QM endpoint (receiver) cannot have more than two
midpoints (e.g., QM-MD7x2 or other QM switchers). Refer to the following
diagram when configuring a QM network.
QM Network Topology
Installer’s Toolbox
The Installer's Toolbox (replacement for Crestron Viewport, you may continue
use Viewport if desired) is a broad-based software package that accomplishes
multiple system tasks, primarily using an RS-232 or TCP/IP connection between
a PC and one or more Crestron control systems.
You can use the Installer's Toolbox to:
•
Observe system processes.
•
Upload operating systems and firmware.
•
Upload programs and touchpanel projects.
•
Set or change device Network IDs.
•
Change serial numbers.
•
Run scripts to automate tasks.
•
Perform system diagnostics, and much more.
The Installer's Toolbox allows you to perform these functions using simple
graphical views and click and drag methods.
●
QuickMedia Receiver: QM-RX
Operations Guide – DOC. 6333
12
Summary of Contents for QuickMedia QM-RX
Page 1: ...Crestron QM RX QuickMedia Receiver Operations Guide...
Page 4: ......
