Crestron
QM-MD7x2
QuickMedia™ Matrix Switcher/Mixer
SYS (System)
Press this button to set the MD7x2 to the system mode. When the accompanying
LED is illuminated, all switching functions are controlled by the Crestron control
system. While in the system mode, routing paths for each input can be viewed on the
front panel by pressing an input or output button. For more information on the
MD7x2’s operating modes, refer to “Operating Modes” on page 77.
LOCAL
Press this button to set the MD7x2 to the local mode. When the accompanying LED
is illuminated, all switching functions are controlled by MD7x2’s front panel. For For
more information on the MD7x2’s operating modes, refer to “Operating Modes” on
page 77.
ENTER
When switching signals in the local mode, switch changes are not implemented until
the
ENTER
button is pressed. After selecting an input source and an output
destination, press
ENTER
to implement the change.
IN (1 through 7)
Select an input source to view or switch (depending on the selected operating mode)
by pressing the corresponding
IN
button. If audio break is enabled (indicated by the
AUDIO BREAK
LED), only the audio or video portion (indicated by the
A
or
V
LED) will be switched or viewed (depending on the selected mode). For information
on operating modes and selecting input sources, refer to “Operation” on page 77.
LOCAL MIC 1 & 2
Press this button to add the signal feed from the local microphone inputs to the audio
mix.
OUT (1 and 2)
Select an output destination to view or switch (depending on the selected operating
mode) by pressing the corresponding
OUT
button. If audio break is enabled
(indicated by the
AUDIO BREAK
LED), only the audio or video portion (indicated
by the
A
or
V
LED) will be switched or viewed (depending on the selected mode).
For information on operating modes and selecting output destinations, refer to
“Operation” on page 77.
AUDIO OUT (1 & 2)
Use these buttons to adjust the speech and program audio volume levels for outputs 1
and 2. Press
SELECT
to toggle between speech audio, program audio, speech and
program audio, or none. Adjust the selected volume level (indicated by LED) by
pressing the
J
or
K
buttons.
SETUP LED and Pushbutton
The MD7x2 is TSID ready. Located on the rear of the MD7x2, the
SETUP
pushbutton and its associated LED are located on the rear panel and are used for
setting up the unit’s network ID during the initial configuration of a Cresnet system
or when the device is being added/replaced. Refer to “Method B (Touch Settable
ID)” on page 18 for detailed information.
Operations Guide - DOC. 6273
QuickMedia™ Matrix Switcher/Mixer: QM-MD7x2
•
13
