© Copyright 2010, Creative Playthings
YORKTOWN
19794-300 Rev J (05-20)
Page 10
ASSEMBLY INSTRUCTIONS
Step 3 — Porch Sandbox Ends:
Position the Sandbox Front (AL) and Sandbox Back (AK)
as shown. The counter-bored holes at one end should face
the inside of the gym. The hole at the center should face the
outside of the gym and be offset to the bottom of the board.
Fasten each Sandbox End to the Sandbox Center using four
5/16 x 3" Lag Screws with four 5/16" Flat Washers. Pass
each Lag Screw through a Flat Washer, then through a hole
in the Sandbox Center, and into the appropriate pilot hole in
the end of a Sandbox end.
Step 4 — Porch Posts & Sandbox Side:
Fasten the two Porch Corner Posts (O) to the Sandbox Ends
using four 5/16 x 4" Hex Bolt Assemblies as shown.
Fasten the remaining Sandbox Side (M) to the Porch Corner
Posts using four 5/16 x 4" Hex Bolt Assemblies.
AK
M
O
AL
