© Copyright 2010, Creative Playthings
YORKTOWN
19794-300 Rev J (05-20)
Page 14
ASSEMBLY INSTRUCTIONS
Step 13 — Angle Braces (continued.):
Level the play set. Plumb the Posts. Tighten all connections
except the Angle Braces. Do not over tighten.
Position all of the Angle Braces with the angled ends flat
against the Post nearest to each. With a pencil, mark the
position where the holes in the Angle Braces rest against the
Posts. At each mark drill a 3/16" diameter x 2" pilot hole in
the Posts. Fasten the Angle Braces to the Corner Posts us-
ing one 5/16 x 3" Lag Screw and Flat washer in each Angle
Brace (B).
Note: The Stringers have been omitted from the illustration
for clarity.
Step 15 — Narrow Platform Boards:
Locate three Narrow Platform Boards (G). Two can be found
in one box and third is in another. Place the Narrow Platform
Boards as shown. The edge of the boards should align with
the corner of the adjacent Post. Fasten the Narrow Platform
Boards to the Stringers with eight #8 x 2" Flat Head Wood
Screws for each board.
AF
G
Step 14 — Stringer Flanges:
If your gym is to be assembled with the lower Clubhouse
option, omit this step.
Just make sure that the Clubhouse
panel is snug against the bottom of the stringers to lend sup-
port to the center of the platform.
Position one Stringer Flange (AF) under a set of Center and
Inner Stringers. It should center on the Stringers, equidistant
from the Left & Right Platform Supports. The holes are not
symmetrically placed; rotate the Flange so the holes land
on the stingers and not on a gap. Drill a 3/16" Pilot hole 1"
deep into the stringer and fasten the Stringer Flange using
1/4 x 1-1/2" Lag Screws and 1/4" Flat Washers. Continue
securing the Stringer Flange to the Stringers with pilot hole
and Lag Screws.
Repeat with the two other Stringer Flanges and Stringer
sets.
Use 3/16" dia. pilot holes
