YORKTOWN
19794-300 Rev J (05-20)
© Copyright 2010, Creative Playthings
Page 9
ASSEMBLY INSTRUCTIONS
Step 1 — Sandbox Base & Corner Posts:
Separate and identify hardware and components. Lay the
components on the ground close to the work area. Have the
separated hardware nearby on a flat surface.
Locate four Corner Posts (D), two Sandbox Ends (AJ), one
Sandbox Side (M), and one Sandbox Center (AD).
Fasten one Corner Post (D) to one Sandbox End (AJ) and
one Sandbox Side (M) using four 5/16 x 4" Hex Bolt Assem-
blies as shown.*
* Note: A Hex Bolt Assem-
bly consists of one Hex Bolt,
one Lock Washer, one Flat
Washer and one Weld Nut.
D
D
AD
AJ
AJ
AJ
AJ
M
M
M
The Yorktown gym is built using the frame of the Lexington gym as a base
structure. When assembling the this gym, set aside the Lexington instructions
and follow the steps in this document.
Note: The large hole at the
top of the post should face
the inside of the gym.
The side where the
porch will mount
Step 2 — Tower Base Assembly:
Following the same procedures as step 1, assemble the
remaining Corner Posts (D), Sandbox Ends (AJ), Sandbox
Side (M), and Sandbox Center (AD). Be sure to note the po-
sition of the large holes at the top of each Corner Post. The
holes should face the inside of the Gym.
