YORKTOWN
19794-300 Rev J (05-20)
© Copyright 2010, Creative Playthings
Page 19
ASSEMBLY INSTRUCTIONS
Step 26 — Mount Ridge Cap:
Before putting the Ridge Cap in place, drill a series of 1/8" di-
ameter pilot holes through the top board of each roof panel.
The pilot holes should be at least 3" from the end of the roof
board and approximately 3/4" from the top edge. Space the
pilot holes every 10 to 12 inches.
Put the Ridge Cap in place at the peak of the roof, as shown.
The ends of the Ridge Cap should be flush with the ends of
the roof.
From inside the Gym, fasten the Ridge Cap using #8 x 1-1/4"
screws, through the pilot holes and into the Ridge Cap.
Step 27 — Dormer & Gable Fans:
Assemble and install the Dormer as directed by the instruc-
tions included in the Dormer package.
Install the Gable Fans as directed by the instructions includ-
ed in the Gable Fan package.
AP
AO
Step 28 — Assemble Panel Frame:
Locate four Panel Frame members (V), four Panel Blocks
(Y), and two End Panel Caps (T).
1 — Fasten one Panel Block to each end of the a Panel
Frame member using two #10 x 2-1/2" Screws each, as
shown.
Pilot drill for each screw using a 1/8" diameter
drill
.
2 — Flip the assembly and fasten another Panel Frame
member to the Panel Blocks using the same method.
3 — Fasten one End Panel Cap, as shown using six #8 x
1-5/8" Screws.
Build a second Panel Frame with the remaining parts.
V
Y
T
2
1
3
