© Copyright 2016, Creative Playthings
NORTHBRIDGE WITH TENT
19949-100 Rev C (05-18)
Page 16
ASSEMBLY INSTRUCTIONS
STEP 23 – Platform Boards:
Lay the Deck Boards (D) and Center Deck Board (E) across
the Stringers and Inside Beams in the pattern shown at right.
Push the outer-most Deck Boards tight against the Posts.
Space the other Boards evenly between the outer-most
Boards. Make sure the holes in the Center Deck Board align
with the holes in the Swivel Stringer. Secure the Boards us-
ing #8 x 1-5/8" Screws in each small hole. Do not use screws
in the larger holes in the Center Deck Board.
Place one End Deck Board (F) so it
overhangs the Stair
Platform End by 1/4"
. Evenly space another End Deck
Board between the first and the adjacent Deck Board. Se
-
cure the End Deck Boards using #8 x 1-5/8" Screws in each
small hole.
Repeat with the remaining End Deck Boards at the other
end of the platform,
overhanging the Ladder Platform End
1/4".
STEP 21 – Secure Rungs:
Secure the Rungs using #10 x 2-1/2" Self-Drilling Screws
through the pre-drilled holes from below. Drill the Screws up
through the steel pipe until the head of the screw is flush with
the surface of the wood.
STEP 22 – Stringers:
Fasten the Stringer (AF) to each Platform End in the position
shown using one 5/16 x 4" Lag Screw and Flat Washer in
each end. The wide surface of the Stringer should be flush
with the top of the Platform Ends.
Fasten the Swivel Stringer (AG) to each Platform End in
the position shown using one 5/16 x 4" Lag Screw and Flat
Washer in each end. The wide surface of the Stringer should
be flush with the top of the Platform Ends.
AF
AG
E
D
D
D
D
D
D
D
D
F
F
F
F
Front of
the Gym
Parts omitted
for clarity.
1/4" Overhang
#10 x 2-1/2" Self-
Drilling Screw
5/16 x 4" Lag Screw
