© Copyright 2016, Creative Playthings
NORTHBRIDGE WITH TENT
19949-100 Rev C (05-18)
Page 20
ASSEMBLY INSTRUCTIONS
STEP 33 – Tire Swivel & Tire Swing:
The Tire Swivel can be found in the Tire Swing box. Fasten
the Tire Swivel to the Bottom of the Swivel Stringer using
four 5/16 x 2-1/2" Hex Bolt Assemblies through the Swivel
Stringer and Center Deck Board as shown. Be sure to use
Weld Nuts at the top, set into the Center Deck Board.
Locate the Tire Swing Assembly (AT) and place it be-
neath the Gym Platform. Make sure that the hard-
ware is fastened firmly to the Tire and that the
chains are not tangled.
Using the included quick-links, fasten each chain
to the Tire Swivel, as shown. The height of the
Tire Swing should be adjusted by putting the
quick-link through a lower link in the chain. The
standard installation is to loop the quick links to
the third link from the End of the Chain.
Tighten the quick-links using a C-wrench.
STEP 32 – Ladder Slat:
Place the Ladder Slat (A) against the underside of the Rung
Leg and Rung Support. The top of the Ladder Slat should be
up against the bottom of the Platform End.
Secure the Ladder Slat using four #8 x 1-5/8" Screws.
A
AH
STEP 34 – Cargo Net:
Fasten the Cargo Net (AH) to the Stair Platform End by pass-
ing the end of each rope through a hole and tying a figure
eight or overhand knot. Approximately 1" of rope should ex-
tend beyond the knot when fully tightened. Pull down on the
cargo net to tighten the knots.
Fasten the bottom of the Cargo Net to the Rope Base Rail by
passing the end of each rope through a hole and tying a knot.
At least 1" of rope should extend beyond the knot.
It is important that the Cargo Net is as taut as possible. Peri-
odically check the knots are secure.
Be sure there is a space of at least 9" between the top
horizontal rope and the bottom of the Stair Platform End.
Deck Boards shown cut-
away for clarity. Do not
cut Deck Boards when
assembling
Use the 3rd link
on each chain.
Overhand
Knot
Figure 8
Knot
≥ 9"
#8 x 1-5/8"
Screw
5/16 x 2-1/2"
Hex Bolt
