Craftmatic
®
L-132 290-0001-b
18
remote controL Programming
(separating 2 bases)
Reprogram Two Remote Controls for Individual
Base Operation
- Bases are factory programmed to
operate individual bases. To reprogram bases synced
to multiple remote control, perform the following
numbered procedure. Individual base operation will
result.
If programming fails, initiate the programming
procedure a second time.
REMOTE CONTROL 1
REMOTE CONTROL 1
BASE 1
BASE 2
steP 1
UNPLUG
both bases from the electrical power
source. Wait 2 minutes, then
PLUG
base 1 back
into electrical power source.
steP 2
Locate the control box for base 1 (attached to the
underside of the base) (
FIGURE 8
).
steP 3
Locate remote control for base 1 (
FIGURE 9
).
steP 4
Simultaneously press and hold the
learn button
on
the base 1 control box (
FIGURE 8
) and the
head
up button
remote control 1 (
FIGURE 9
). Hold both
buttons until base 1 begins to move or the massage
motors start. Release both buttons.
steP 5
PLUG
base 2 back into electrical power source.
steP 6
Locate the control box for base 2 (attached to the
underside of the base) (
FIGURE 8
).
steP 7
Locate remote control for base 2 (
FIGURE 9
).
steP 8
Simultaneously press and hold the
learn button
on
the base 2 control box (
FIGURE 8
) and the
head
up button
remote control 2 (
FIGURE 9
). Hold both
buttons until base 2 begins to move or the massage
motors start. Release both buttons.
Independent operation is now restored. Remote control
1 operates base 1; remote control 2 operates base 2.
LEARN
BUTTON
CONTROL
BOx
FIGURE 8
HEAD UP
BUTTON
FIGURE 9
