Craftmatic
®
L-132 290-0001-b
16
remote controL Programming
(1 remote controls - 2 bases)
Program Two Remotes to Operate One Base
- Bases
are factory programmed to operate individual bases. To
program one remote to operate both bases, perform the
following numbered procedure.
If programming fails,
initiate the programming procedure a second time.
steP 5
Repeat Steps 2-4 with base 2.
steP 6
Operate remote to verify base functions.
One remote control is now programmed to operate
both bases.
BASE 1
BASE 2
steP 1
Plug both bases into the electrical power source.
steP 2
Locate the control box for base 1 (attached to the
underside of the base) (
FIGURE 8
).
steP 3
Locate one remote control (
FIGURE 9
).
Note: The
second remote control is not needed. retain as a
spare.
steP 4
Simultaneously press and hold the
learn button
on
the base 1 control box (
FIGURE 8
) and the
head
up button
on the remote control (
FIGURE 9
). Hold
both buttons until the base begins to move or the
massage motors start. Release both buttons.
LEARN
BUTTON
CONTROL
BOx
FIGURE 8
HEAD UP
BUTTON
FIGURE 9
