17
Craftmatic
®
L-132 290-0001-b
remote controL Programming
(2 remote controls - 2 bases)
BASE 1
BASE 2
Program One Remotes to Operate Two Bases
- Bases
are factory programmed to operate individual bases.
To synchronize bases, perform the following numbered
procedure.
If programming fails, initiate the
programming procedure a second time.
REMOTE
CONTROL 1
REMOTE
CONTROL 2
steP 1
Plug both bases into the electrical power source.
steP 2
Locate the control box for base 1 (attached to the
underside of the base) (
FIGURE 8
).
steP 3
Locate remote control for base 1 (
FIGURE 9
).
steP 4
Simultaneously press and hold the
learn button
on
the base 1 control box (
FIGURE 8
) and the
head
up button
remote control 1 (
FIGURE 9
). Hold both
buttons until base 1 begins to move or the massage
motors start. Release both buttons.
steP 6
Locate the control box for base 2 (attached to the
underside of the base) (
FIGURE 8
).
steP 7
Locate remote control for base 1 (
FIGURE 9
).
steP 8
Simultaneously press and hold the
learn button
on
the base 2 control box (
FIGURE 8
) and the
head
up button
remote control 1 (
FIGURE 9
). Hold both
buttons until base 2 begins to move or the massage
motors start. Release both buttons.
steP 9
Repeat Steps 6-8 with base 2 and remote control 2.
steP 10
Operate both remotes to verify base functions.
Two remote controls are now programmed to operate
both bases.
LEARN
BUTTON
CONTROL
BOx
FIGURE 8
steP 5
Repeat Steps 2-4 with base 1 and remote control 2.
HEAD UP
BUTTON
FIGURE 9
