Craftmatic
®
L-132 290-0001-b
12
instaLLation
steP 10
Install headboard brackets to the adjustable base frame as follows:
a. Raise the head section of the adjustable base (with remote
control) to gain access to the base frame.
b. On one side of base frame, locate (2) holes for channel
connector mounting (
FIGURE 6
).
c. Position channel connector so that the flat side is flush
against base frame. Attach channel connector to base frame
using (2) 1½ inch long hex head bolts/nuts (
FIGURE 6
).
Tighten bolts.
Note: For units with 74” base length, use
inner mounting holes. For units with 80” base length, use
outer mounting holes
.
d.
Using (2) 3 inch long carriage bolts/nuts, attach (1)
headboard bracket channel to channel connector (
FIGURE
6
). Hand tighten bolts/nuts (loosely) to allow adjustment of
the headboard bracket channels.
e. Attach (1) headboard bracket flange to one of the bracket
channels with (2) 1 inch long hex head bolts/nuts (
FIGURE
6
). Tighten bolts.
f. Repeat procedure to attach the other headboard bracket.
80” BASE
LENGTH
MOUNTING
HOLES
74” BASE
LENGTH
MOUNTING
HOLES
3 INCH LONG
CARRIAGE BOLTS/
NUTS
ADjUSTABLE
BASE HEADBOARD
BRACkET ASSEMBLY
MOUNTING POINTS
1 INCH LONG HEx
HEAD BOLTS/NUTS
1.5 INCH LONG
HEx HEAD
BOLTS/NUTS
HEADBOARD
BRACkET
CHANNEL
HEADBOARD
BRACkET
FLANGE
CHANNEL
CONNECTOR
FIGURE 6
note: if more floor clearance
is required, mount headboard
bracket flange with extension
facing upward.
