Se
ctio
n
5
- En
gin
ee
r’s
Pro
gra
m
Technical Manual
4. CoEx® Cleaning:
a.
CoEx® Tablet Clean - Initiates a clean cycle
b. CoEx® Cleaning - enables or disables the timer within the machine software. If
enabled the machine will show a warning each time the door is open after seven
days, if the cleaning cycle has not been completed after ten days all drinks using
the CoEx® brewer will be disabled. A successful clean cycle will reset this timer.
c. Last CoEx® Clean - will show the time and date a CoEx® clean cycle was completed
5. CoEx® Pump Mode - this indicates the selected pump mode, either Single or Dual.
6. CoEx® Flow Rate - this shows the flow rate last recorded through the CoEx® unit any
value above 0.5ml/s is acceptable. If the flow is less it will put the CoEx® module out
of service and display a No Water CoEx® error.
7. Prevend Heat - This enables the brewer components to be flushed through with hot
water after a period of inactivity. This ensures the brewer components are warm and
therefore the vend hot.
Enabled/Disabled - to enable or disable the Prevend Heat option.
Water Quantity - enables the amount of hot water used during the flush to be
set.
Inactivity Period - the period of time after the last vend the flush will occur.
5.7.21 Oltre Brewer
This menu enables the following options for the Oltre brewer to be set-up.
1. Tea Brewer Vend Counter - this displays the current Tea Brewer Vend Count. There is
also the option to reset this counter.
2. Tea Belt Usage Counter - this displays the current Tea Belt Usage Count. There is also
the option to reset this counter. It is recommended that the belt is replaced every 5000
vends to maintain the highest quality drink.
5.7.22 Water Only - No Cup
This disables the cup drop unit and forces the user to use their own cup when vending Hot
or Cold water.
If SureVend
TM
is enabled the user’s cup must be in the dispense area before the water is
dispensed.
5.7.23 Stick Stirrer Settings
This menu enables the configuration of the dropping of a Stick Stirrer, depending on the
drink dispensed and when.
5.7.23.1 Stick Stirrer
This option enables the Stick Stirrer dropper to be used, which drinks receive a stirrer and
whether it is dropped at the start or end of the vend.
1. Disabled - this disables the Stick Stirrer, no stirrers are dropped.
2. All Selections - a Stirrer is provided for all drinks.
3. Pre set selections - a Stirrer is provided for all drinks with sugar (as defined in the
drinks configuration).
83
Summary of Contents for COTI
