Se
ctio
n
2
- I
n
sta
lla
tio
n
DO NOT USE THE VENDING MACHINE UNTIL THE WORN OR DAMAGED CORD IS
REPLACED.
FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY SUBJECT THE USER TO THE RISK
OF INJURY OR ELECTRICAL SHOCK WHICH CAN BE SERIOUS OR FATAL. PERIODICALLY
INSPECT THE POWER SUPPLY CORD FOR DAMAGE. IF THE CORD BECOMES DAMAGED IT
MUST BE REPLACED WITH THE SAME SIZE AND TYPE CORD. CONTACT CRANE
MERCHANDISING SYSTEMS FOR ASSISTANCE.
The electrical safety of this appliance can only be guaranteed if it is correctly earthed. The
manufacturer declines all liability for damage resulting from a system which has not been
earthed. On no account should it be earthed only to the water supply pipe.
Retrieve the main power cord from inside the Vender firstly connect to the machine then
plug the cord in a properly grounded 120VAC, 15 Amp receptacle (U.S. and Canada). Turn
the power on at the Main Switch (if equipped with a Bill Acceptor, the Acceptor should cycle
twice). If the Display shows “OUT OF SERVICE” refer to the TROUBLESHOOTING SECTION of
this guide.
COIN CHANGERS & OTHER ACCESSORIES
Coti models 608 fresh brew, 609 freeze dried and 610 bean grinder
can have an MDB Coin
Changer installed and can have an MDB Bill Acceptor installed as well.
If the MDB Coin Changer and other MDB accessories are not factory installed, refer
to the instructions received from the manufacturer of the MDB Coin Changer and other
MDB accessories for proper set‐up and installation.
The Vender will support the following Domestic MDB Coin Changers:
All available CPI/MEI MDB
All available Conlux MDB
All available NRI MDB
All available Coinco MDB
The Vender will support the following Domestic MDB Bill Acceptors
All available CPI/MEI/Mars MDB
All available Conlux MDB
All available Cashcode MDB
All available Coinco MDB
The Vender will support MDB Card Readers.
The Vender supports Swipe/Tap for Cashless Vending.
“Select then Pay” workflow for purchasing product is also implemented for both Cash and
Cashless operations.
10
Summary of Contents for COTI
