Se
ctio
n
2
- I
n
sta
lla
tio
n
LINEA
Ensure the work surface can bear the weight load of a fully loaded Vender
(approximately 143 lbs. or 65 kg).
If the Machine will be subject to user misuse or vandalism, it is recommended that
the Vender be secured to the work surface. Due to the large size and weight of the
Vender ensure that the correct equipment is used to move and transport it around site.
ACCEPTABLE AMBIENT OPERATING TEMPERATURE RANGE
COTI and LINEA models manufactured by Crane Merchandising Systems are designed to work
properly in a temperature range 50°F to 90°F (10°C to 32°C) in still air 40% Relative
Humidity, non-condensing.
2.2 Connecting the Water Supply
Your machine should be situated within 3ft of a drinking water supply from potable water
supply.
Note: The water supply should comply with both local and national regulations.
Dynamic water pressure at the stop-tap must be within the limits 14 and 116 psi (1 - 8 Bar).
Crane Merchandising Systems recommend that all hot drinks machine are fitted with a water
filter. This filter must be of food grade quality and able to remove temporary hardness
(scale), heavy metals (lead, copper, iron, cadmium), chlorine and any organic pollutant’s/
discolouration.
Warning! If your Freshbrew or Espresso machine is connected to a water supply and
used without a water filter as specified above, your warranty will be void.
Connect the flexi-hose supplied with your machine to the shutoff valve. Flush the water
supply before connecting the machine. (At least 1gallon)
Note: When connecting your machine to a water supply always use the new flexi-hose
supplied with the machine. Never re-use an existing hose.
Connect the hose to the inlet located on the rear of your machine. Ensure that the seal is
correctly fitted. Ensure that all water supply fittings are tight.
Note: Do not overtighten.
Turn on the water supply at the stop tap and check for leaks.
8
Summary of Contents for COTI
