COVANA OASIS, Installation Manual

Page: 33 / 62

INSTALLATION MANUAL INSTALLATION 33
15) Now connect the bottom harness to the wire
guard connector. The bottom harness is
attached to the key switch cable. Cut the cable
tie that holds the bottom harness. Connect it to
the wire guard connector. (Figure 70)
WARNING

Do not uninstall the wire guard connector. This
could cause permanent damage to the wire
harness.
16) If your cover is completely lowered onto the hot
tub, the exiting wire (Figure 72) seems to have
sufficient tension and the magnetic plate is
properly positioned (Figure 71), skip to next
section,
Lifting mechanism assembly
(continued). If not, follow next steps .
17) Repeat steps 1 to 3 of this section for cover
lifting instructions.
CAUTION

Do not use any sharp or abrasive tools to hold the
outer shell in place while following the next steps.
WARNING

Do not lift corner more than 16 in (40 cm), further
lifting will damage the outer shell.
18) Locate the set screws for the tension holder on
the CTS-70 (Continuous Tension System).
(Figure 72) Lightly unscrew them and pull back
the tension wire until a slight resistance is felt.
Once the resistance is felt, continue pulling
another inch. Check the protruding wire going to
the posts, and if the wire is tight enough,
retighten the set screws.
19) Slide the outer shell back on the inner shell. The
AC light kit has been successfully installed.
CAUTION

When placing the outer shell back on, make sure
that all the steel frames are inside the outer shell.
Also, check all metal inserts before continuing.
Failure to check these items may cause aesthetic
damage.
Magnetic
plate
Set screws
Tension wire
(going to LEDs)
Exiting wire
(going to
operator)
Tension
holder
CTS-70
Wire guard
connector
Bottom harness
Figure 70
Figure 71
Figure 72