COVANA OASIS, Installation Manual

Page: 20 / 62

20 INSTALLATION INSTALLATION MANUAL
14) Remove the two long U-frame pieces, the two
short U-frame pieces and both jacks located at
the bottom of the crate. Lay these parts down in
a safe place. (Figure 33)
CAUTION

The small U-frames are nailed in; remove them
by hand to prevent any aesthetic damage.
15) With the help of another person, gently lay the
crate horizontally on its back by using the pivot
point. (Figure 34) There should be one person
on each side of the crate.
CAUTION

Dropping the crate could damage the cover.
16) Remove the cardboard top and sides by simply
unfolding them on the ground. (Figure 34)
17) If your COVANA cover was delivered with roller
shades, remove the cardboard cylinders from
the holes in the side panels and place them in a
safe place.
18) Gently hammer off the last wood furring strips
on the front of the crate. Consider hammering
the side panel in an outward direction to
prevent damaging the COVANA cover.
(Figure 35)
CAUTION

Be careful not to damage the cover during this
process. (Figure 35)
19) Step 1: Use a Phillips screwdriver to remove the
two M6 x 20 mm screws. Step 2: Use a 3/8
″ (10
mm) socket wrench to remove the two other lag
bolts. Step 3: Repeat steps 1 and 2 for all four
corners. (Figure 36 and Figure 37)
CAUTION

Carefully remove all four brackets. Failure to do
so might damage the cover when removing the
crate sides.

Flatten any protruding nails.
Jacks
U-Frames
Cardboard
top
Cardboard sides
Pivot
point
Furring
Step 1
M6 x 20 mm
Step 2
3/8
″ lag bolt
Figure 33
Figure 34
Figure 35
Figure 36
Figure 37