COVANA OASIS, Installation Manual

Page: 25 / 62

INSTALLATION MANUAL INSTALLATION 25
11) Install the long aluminum U-frame over the left
driveshaft and ensure it lines up with motor-side
and non-motor-side jack assemblies. Fasten it
in place using two hexagonal 5/16
″-18 x 2″
bolts, two 5/16
″-18 nylon-insert lock nuts and
four 5/16
″ plastic washers per side. Use the 1/2″
(13 mm) socket wrench and spanner as tool .
Do not fully tighten all bolts. The driveshaft
may fall off during operation, and the re-
assembling can be done faster when the
bolts have not been fully tightened.
(Figure
49)
12) Perform steps 8 to 11 on the opposite side.
13) Install one unpainted metal coupler on each end
of the front frame cut-out. (Figure 50)
14) Align one unpainted metal coupler with the
holes on each end of the front frame cut-out.
Use the provided 1/4
″-20 x 3/4″carriage bolts,
1/4
″-20 nylon-insert lock nuts and fasten the
hardware with the 7/16
″ (11 mm) socket wrench
and spanner. There is one metal coupler per
side. (Figure 50)
Unpainted
metal coupler
¼-20 carriage
bolt
1/4-20 nylon
insert lock nut
Figure 50
Figure 49
Motor-side
direction
Non-motor-side
jack assembly
Plastic
washer
Nylon-insert
lock nuts
Plastic
washer
5/16-
18 x 2”
Hex bolt