COVANA OASIS, Installation Manual

Page: 19 / 62

INSTALLATION MANUAL INSTALLATION 19
10) For each jack, use the 7/32
″ (5.5 mm) Allen key
to loosen
—but not fully remove—the 3/8″-24 x
1
″ bolt holding the jack to the bracket. There is
one bolt per side. Do not discard this bolt and
bushing; they are required to assemble the
COVANA cover.
(Figure 30)
11)
Remove the white foam paper on the cover’s
top. (Figure 31)
12) With the help of another person, remove the
motor frame assembly from the crate. Place one
hand under the horizontal portion of the motor
frame and the other one on the vertical jack.
(see Figure 31 for hand positioning). Handle
and carry the assembly with care, so that the
jacks follow the natural bending of the U-frame.
Place the motor frame on a level surface to
ensure the assembly does not fall. (Figure 31)
CAUTION

Do not twist the assembly, since this may cause
mechanical failure to the operator and chain
assembly.

Jacks may be greasy; wash your hands after
handling them or use gloves.
13) Pry off the footing piece of wood using your
hands or a hammer if needed. There is one
piece per side. (Figure 32)
CAUTION

Do not damage the jack or frame components
resting at the bottom of the crate.

Flatten any protruding nails.
Figure 30
Figure 31
Figure 32
32
Location of foam
paper