COVANA OASIS, Installation Manual

Page: 28 / 62

28 INSTALLATION INSTALLATION MANUAL
19) Unscrew the 3/8
″-24 x1″ Allen bolt with a 7/32″
(5.5 mm) socket on the top of all four jack
assemblies. Put these parts in a safe place.
20) Slide the sleeves over all four jacks. (Figure 54)
Be sure to align the opening at the bottom of the
sleeves with the U-frames attached. (Figure 55)
21) Screw in the Phillips M6 x 20 mm screws at the
bottom of all four sleeves. (Figure 56)
CAUTION

Be sure that the nylon washer is on the outside of
the outer sleeve. (Figure 56)
22) Make sure the all-weather seal on each post is
slid all the way down against the outer sleeve.
(Figure 57)
WARNING

Failing to properly position this part may cause
serious damage to post mechanism.
23) Install the 3/8
″-24 x1″ Allen bolt with a 7/32″ (5.5
mm) socket. The narrow part of the bushing
faces down for each post. (Figure 58)
CAUTION

Make sure that the wider part of the bushing is
facing up when you screw in the 3/8
″-24 x1″ Allen
bolt.

Ensure the hole in each top plate is aligned with
the jack
assembly’s threads before installing the
screw.
M6 screw
1/4
″
Nylon
washer
All-weather
seal
Figure 55
Figure 56
Figure 57
Figure 54
Figure 58
Outer
sleeve