Cordivari CLAUDIA EL., User Manual, Page: 29 / 56

English
• Automatic activation (factory settings)
The device detects a temperature fall. An opened window, a door to the
outside, can cause this temperature fall.
Note:
The difference between the air from the inside and the outside
must cause a significant temperature fall to be perceptible by the device.
This temperature drop detection triggers the change to Frost Protection
mode .
• Manual activation
By pressing for more than 5 seconds, the device will switch on Frost
protection mode.
5 sec.
• Frost protection digital meter
When the device performs a lower temperature cycle due to opened
window, a meter appears on the display to show he cycle time. The
counter is automatically reset the next time Frost protection by opened
window is activated (automatic or manual activation).
• Stop the Frost protection mode
By pressing any button, you stop the Frost protection mode.
Note: If a temperature rise is detected, the device may return to the
previous mode (active mode before the open window detection).
11.11 Optional: Remotely management by infrared remote control
Your towel rails can be managed by a remote control with infrared transmission
through its IR receiver located on the front of the controller.
• Scheme
Boost
Display of the ambient temperature
Adjustment of the setting temperature
desired and the boost duration
Selection of the Auto, Comfort, Eco, Frost
protection modes
Note : the buttons , , and have the same features as the
buttons on the controller.
• Operation
Position the remote control toward the infrared receiving window of the
device. Check that there is no obstacle between the remote control and
the infrared receiver to disturb the transmission.
Infrared
receiving
window
2
12. User settings
12.1 Access
Access to the User settings in 3 steps:
From Auto, Comfort, Eco or Frost protection mode:
Information
display
1
Information
display
1
= User settings
Press for 5
seconds
1
Press twice
2
Press briefly
3
Setting sequence :
Backlighting → Eco mode temperature lowering-level → Frost protezione
temperature → Comfort setting temperature limits → Maximal Boost duration
→ Maximum ambient temperature → Temperature unit
12.2 Backlight setting
1- Three modes can be set:
= Temporary backlighting: Backlight of the display when a button is pressed
= Non-stop backlighting: Backlight of the display all the time
= In this version, the device will work according to the L1 mode.
- 29 -
Cod. 1910000000276 - nv01