CorDES Proprietary Information
11
Inspect the shipping container for signs of damage during shipping, storage, or handling. Open
the container and carefully remove the CDNA-041G from the box. Inspect the unit for any
external damage; this includes checking the power switches, connectors and mounting tabs.
Verify the items in the supplied equipment list above are enclosed.
4.2
Mounting and Making Connections
The CDNA-
041G is designed for mounting in a standard 19” EIA equipment rack using
side
mounting slide rails with front and rear rack attach for most support. Rail attachment points are
provided on the side of the unit.
No special tools are required for mounting the CDNA-041G. A Philips screwdriver is required to
install the slide rails and tighten the rack mounting screws (not supplied).
To install the CDNA-041G (with slide rails) and ECUs:
1. Unscrew the five (5x) front panel thumb screws to remove the front panel faceplate.
a. Optionally install
the side rails on the unit and install the unit in the 19” rack.
2. Slide the unit into the rack and secure it in place by screwing four #10-32 flush mount
screws.
3. Slide one or two ECU GOE units into the chassis slots with the faceplate removed.
4. Install the faceplate and secure it in place with the five thumb screws attached to the
plate.
Make the data and power cable connections:
1. Connect the rear Plain Text and Cipher Text serial data cables and DC power cables
as shown in Table 4-1 below.
2. Insert the SFP optics into the cages and connect the front panel Ethernet ports to the
network as shown in Table 4-2 below.
3. Connect the CDNA-041G front panel remote management interface cable to the
network.
4.
Connect the ECU’s Host Control Interface (HCI) port (J2) to the appropriate network.
5. Connect both AC power cables to the chassis and power source.
•
Note: Both AC supplies should be connected to power. The unit will emit a
constant alarm tone if one of the supplies is not powered or fails.
ECU[0] Connections
ECU[1] Connections
CDNA-041G
ECU[0]
CDNA-041G
ECU[1]
ECU[0] Power
J1
ECU[0] Power
J1
PT[0]
J3
PT[2]
J3
PT[1]
J5
PT[3]
J5
CT[0]
J4
CT[2]
J4
CT[1]
J6
CT[3]
J6
Table 4-1 CNDA-041G to ECU Connections
