CorDES Proprietary Information
16
Figure 10 Global Device Settings
This page allows you to modify all the CDNA operational parameters.
Note1: No changes
are made to any of the unit’s configuration settings until the “Apply &
Restart
” button (Upper right) is selected and the device is rebooted. Upon clicking “Apply &
Restart” the unit stores the updated setting to internal Flash memory on the unit and they will
persist unless reconfigured by the user. After the configuration is stored, the unit auto-reboots
with the new parameters and resumes traffic processing. The store and reboot operation takes
under one minute.
Note2: The Global Settings section is for future integrated control of the 2 ECUs via the MMI
interface. At this time these parameters are not used and can be ignored.
On this page there are 5 sections that are described below to modify each of the operational
parameters. Some of these parameters must be set to match the operational configuration of
the embedded GOE:
