CONVEY-ALL 1685-SP, Operator'S Manual

Page: 30 / 64

Operator’s Manual: 1600-SP Series Conveyor
3-12 Revised 07.2017
Fig 40 - Swing-out winch
Fig 41 - Transport hook (a), winch hook (b)
Fig 42 - Hydraulic motor on swing-out
a
b
Swing-Out Winch:
A winch is located on the side of the main conveyor’s
hopper. The cable is routed through the hoist. It is
attached by a hook to the front of the hopper. It is
used to raise and lower the swing-out.
Remove the cable hook from the end of the hopper,
when the swing-out is sitting on the ground. Then, it
can be pivoted into position.
Transport Hooks:
There are 2 hooks at the end of short chains (a), to
hold up the swing-out’s hopper.
When the swing-out is raised off the ground, with the
winch (b). Attach both hooks to the eyelets on either
of the hopper frame.
This will relieve pressure from the winch. It will also
secure the swing-out for transportation or storage.
Hydraulic Motor:
The swing-out conveyor belt is run by hydraulics. It
needs to an external source, such as a tractor.
Hydraulic Oil Flow Regulator:
If equipped with a swing-out, a regulator is added to
divide the hydraulic oil flow between main conveyor
and swing-out. It has been preset by the factory to
optimize the flow to both the movements and belt
speed.
DO NOT ADJUST.
Fig 39 - Hydraulic oil flow regulator