CONVEY-ALL 1685-SP, Operator'S Manual

Page: 29 / 64

Operator’s Manual: 1600-SP Series Conveyor
Revised 06.2019 3-11
Fig 35 - Discharge of 10 inch swing-out
Fig 36 - Hydraulic valves
Fig 37 - Front view of valves. Mover kit front (a), Belt (b)
Fig 38 - Rear view of valve. Mover kit rear (a)
a
b c
a
a
b
Discharge Spout:
The discharge spout is attached to the main conveyor
above it’s hopper. The spout can tilt and rotate as
needed with the movement of the swing-out.
Use the removable cover, attached in front of the
spout, to access the main belt.
WARNING: Rotating Belt Hazard
Be sure the cover is in place before running
the belt.
Hydraulic Valve Bank:
The set of 3 hydraulic valves located above the
hopper of the swing-out, operates the following
movements:
a. Drives the wheels, moving the swing-out around
the main conveyor.
b. Raises/Lowers the swing-out’s mover kit wheels,
lifting the hopper off the ground.
c. Conveyor belt control includes detent to keep
the belt rotating in only one direction. This valve
controls both the swing-out and main conveyor
belts.
Valve Settings:
a. The speed of the swing-out’s mover kit can be
adjusted. Use the set screw with lock nut below
the valve.
There is another set screw on the rear of the drive
valve, which must also be adjusted.
- Twist set screw “IN” to give less play to the
handle, so the wheels don’t turn too fast.
- Twist it “OUT” giving more play in the handle,
to speed up the wheels.
b. This set screw is for the conveyor belt. It has
been preset by the factory. DO NOT ADJUST.