Operator’s Manual: 1600-SP Series Conveyor
Revised 06.2019
3-17
3.8 CONVEYOR PLACEMENT
Follow this procedure when placing the conveyor
into its working position:
1. Clear the area of bystanders, especially small
children, before starting.
2. Transport the conveyor to the working area.
Refer to Section 3.11
3. Attach the jack. Use it to raise and support the
hopper.
- or -
Start the conveyor’s engine, then lower the
steering wheels.
4. Detach the conveyor from the tow vehicle.
CAUTION: Safety Hazard
Remove hitch from conveyor to prevent
interference and clear a tripping hazard.
5. If not done before, start the conveyor’s engine,
and lower the steering wheel.
6. Retract and store, the jack.
WARNING: Electrocution Hazard
Ensure enough clearance from overhead
obstructions, power lines or other
equipment.
7. Drive the conveyor to the working area while it is
in its lowered configuration.
NOTICE: Damage to Equipment Likely
Swing-out conveyor must be lowered and
swung around the hopper, to be inline with the
main conveyor before raising the tube.
8.
IMPORTANT -
If equipped with a swing-out:
Before raising the conveyor tube, lower the
swing-out, and rotate it to be in front of the
hopper.
The swing-out can then follow the main conveyor
as it is positioned over the bin.
Fig 51 - Start engine
Fig 52 - Drive conveyor
Fig 53 - Drive in collapsed position
Summary of Contents for 1685-SP
Page 1: ...SELF PROPELLED CONVEYOR Models 1685 SP 1690 SP 1695 SP OPERATOR S MANUAL ...
Page 4: ...This page intentionally left blank ...
Page 8: ...Operator s Manual 1600 SP Series Conveyor 1 2 08 2016 This page intentionally left blank ...
Page 60: ...Operator s Manual 1600 SP Series Conveyor 6 2 08 2016 This page intentionally left blank ...