5-2
08.2020
Operator’s Manual: 1600-FL Series Conveyor
Conveyor belt doesn’t turn or is slipping
Hopper flashing may be stuck to belt, because it
is running dry and rubber is heating up
Turn off unit! Manually peel flashing up and off
hopper. Then run dry product through to create
barrier between flashing and belt
Conveyor belt loose
Tighten and align
Conveyor belt loose because it has stretched
Remove lacing, cut belt shorter and relace
Conveyor belt frozen to tube from operating in
high humidity conditions in extreme cold
Remove conveyor from area of high humidity and
continue to run empty so the belt dries prior to
freezing
No power
Start engine, increase speed to maximum RPM
Adjust hydraulic pressure
Seized bearing
Check all bearings, Replace any that are rough or
seized
Belt/roller is jammed
Check for sticks, stones, other objects jammed in
belt drive area and remove
Set screw (relief valve) on Dtent control valve on
belt drive valve isn’t set correctly
IMPORTANT:
Do not run hydraulic motor during
this adjustment.
Sweet spot is to turn the set screw all the way
in, then turn back 1-1/2 turns. Turning back/out
increases volume of flow, turning in increases
pressure.
Hydraulic motor on drive roller may be damaged
Hydraulic motor may need to be replaced
Conveyor belt won’t align
Roller lagging may be worn
Replace roller or have it re-lagged
Conveyor Belt Fraying
Belt not aligned
Align and adjust tension
Product leakage
Corner Flashing may not be cupping the roller
tight enough.
Loosen the Flashing Clamp, then adjust the rubber
flashing so it is tight around the roller.
Product may be getting under the belt at the
hopper, traveling up inside the belt and leaking off
delivery end
Replace hopper flashing
Summary of Contents for 1635-FL
