CONVEY-ALL 1635-FL, Operator'S Manual

Page: 31 / 60

08.2020 3-11
Operator’s Manual: 1600-FL Series Conveyor
3.7.2 Stopping Conveyor:
Electric Motor Model:
1. Stop unloading. Wait for conveyor belt to run
empty.
2. Turn power off on conveyor.
3. Turn power off at main panel and unplug
power cord.
Gas Engine Model:
1. Stop unloading. Wait for conveyor belt to run
empty.
2. Move the throttle to idle position.
3. Disengage belt drive.
4. Shut off engine and remove ignition key.
Hydraulic Motor Model:
1. Stop unloading. Wait for conveyor belt to run
empty.
2. Turn conveyor hydraulic system off.
3. Turn power source off.
PTO model:
1. Stop unloading. Wait for conveyor belt to run
empty.
2. Reduce tractor engine speed to low idle.
3. Disengage PTO clutch.
4. Shut off tractor engine and remove ignition
key.
3.7.3 Emergency Stopping:
Although it is recommended that the tube be
emptied before stopping, in an emergency
situation, stop the engine immediately.
See to the emergency. Correct the situation
before resuming work.
3.7.4 Restarting after Emergency Stop:
When the conveyor is shut down inadvertently
or in an emergency, the conveyor belt will still be
covered with product.
Remove as much product from the hopper as
possible, before restating the engine.
Since start-up torque loads are much higher than
normal when belt is full, restart at a low engine
speed. The engine speed can be increased to
full throttle, when the belt is empty.
Now, product can again be unloaded into the
conveyor hopper.
3.7.5 Unplugging:
In unusual moisture, crop or product conditions,
the machine can become plugged. When
unplugging, follow this procedure:
1. Stop the conveyor belt.
2. Turn off the engine.
3. Lock-out, tag-out the controls.
4. Remove product from the discharge and
hopper area.
5. Reposition the conveyor if discharge area
plugs due to lack of clearance.
6. Restart using the same procedure as if after
an emergency stop. Refer to Section 3.7.4