CONVEY-ALL 1635-FL, Operator'S Manual

Page: 30 / 60

3-10 08.2020
Operator’s Manual: 1600-FL Series Conveyor
Fig 26 - PTO attached to tractor
3.7 OPERATING ON SITE
3.7.1 Starting Conveyor:
Electric Motor Model:
1. Have a licenced electrician provide power to
the motor.
2. Plug the power cord from master panel, into
the conveyor.
3. Turn power on at master control panel in the
power source.
4. Turn the conveyor motor on.
Gas Engine Model:
1. Disengage belt drive.
2. Move throttle to its idle position.
3. Close the choke if the engine is cold or if the
unit has not been run for a while.
4. Turn the ignition key clockwise to start the
engine. Release key when engine starts.
5. Run for 2-3 minutes allowing the engine to
warm.
6. Engage the belt drive when engine is running
just above idle.
Note:
Do not engage drive belt
when engine is at full RPM.
7. Now, increase engine speed to full throttle.
8. Start flow of product and unload into the
hopper.
Hydraulic Motor Model:
1. Connect the hydraulic hoses to the tractor.
2. Start hydraulic power source.
3. Turn on conveyor hydraulic system.
PTO Drive Model:
1. Place all controls in neutral.
2. Start tractor and run at low idle.
3. Slowly engage the PTO clutch.
4. Start flow of product and unload into hopper.
5. Increase engine speed to have a PTO speed
of 300 or 350 RPM depending on model.