08.2020
4-3
Operator’s Manual: 1600-FL Series Conveyor
Fig 32 - Top-end electric drive
Fig 33 - Side PTO drive
4.2 SERVICING INTERVALS
Use the Service Record provided on page 4-13,
to keep a record of all scheduled maintenance.
The conveyor belt alignment is preset to run
true under a condition of no load. It is important
to check alignment and make adjustments, if
required, during the initial few minutes of loaded
operation.
Check bearings for wear daily.
The following recommended periods are based
on normal operating conditions. Severe or
unusual conditions may require more frequent
lubrication and oil changes.
Schedules may vary depending on options and
engine model contained in your equipment.
IMPORTANT:
For engine servicing and maintenance,
refer to it’s manual for complete details.
4.2.1 After 10 Hours or Daily:
Electric Motor Units:
1. Grease countershaft bearing, if equipped.
PTO Drive Units:
ROTATING PART HAZARD
Turn off engine/motor. Disconnect power
source, wait for PTO to stop moving.
IMPORTANT:
Keep the PTO shaft and yokes
well greased at all times.
2. Grease PTO shaft and yokes.
Summary of Contents for 1635-FL
