Provisioning
XW-210 WiFi™ Users Manual
3.2
WPS (Wi-Fi Protected Setup)
The WPS
Push button method
, provides a simple method for attaching the XW-210 to a wireless
network without needing to use any setup pages. Although using this method to connect the XW-210 to
the network is simple, you will not be able to access the XW-210 web server unless you know the IP
address that was assigned by the DHCP sever (router) or unless mDNS services are available on your
device. For this reason, it is recommended that you use this method of configuration only when the XW-
210 units have been pre-configured to operate in a non-web-server mode or when you have full access
to the DHCP server so you can obtain the IP address that was assigned.
To begin, press the WPS button on your wireless router or access-point. You will generally have about
two minutes to connect wireless devices to the network with WPS. Now press the “WPS” push button on
your XW-210. After a few seconds, the XW-210 should register itself with the router or access-point. If
WPS fails, the XW-210 will automatically enter the access point mode.
The XW-210 will use DHCP to obtain an IP address after a successful WPS association. Additionally, the
connection information is also broadcast using mDNS. If you need to access the XW-210 using its
internal web server you will need to obtain the IP address that was assigned to the XW-210 through your
DHCP server or router. Alternatively, if using an mDNS capable device, it may be accessed by entering
the following into the address bar of your web browser:
http://xw-210.local/setup.html
Page 20
Xytronix Research & Design, Inc.
Summary of Contents for WebRelay Wireless XW-210I
Page 1: ......
