Control Page
XW-210 WiFi™ Users Manual
Section 5: Control Page
The relay, digital input and temperature sensors can be monitored and controlled using a web browser,
by sending text commands to an XML status/control page, and/or by sending Modbus/TCP requests.
5.1 Browser Operation
Once the XW-210 is set up, users can access the
Control Page
using a web browser. There are two
ways to do this. The first is by typing the IP address of the XW-210 directly into the web browser address
bar. For example, using the default IP address, the user would enter http://192.168.1.2. If the IP address
is changed from the default, the user must use the new IP address. Note that if any port is used other
than the default port 80, the port must also be included in the request. For example, accessing the unit at
port 8000 would be as follows: http://192.168.1.2:8000.
The following screen appears when the Control Page is requested from the address bar. This example
has all of the optional resources enabled. The I/O on the control page updates every three seconds.
The Control Page is normally what users see and use and it can be highly configured to fit your needs.
The
Control Page Setup
tab has check boxes that determine if a specific resource is displayed or not.
The description (text) shown for certain rows is also specified in the
Control Page Setup
tab.
Page 54
Xytronix Research & Design, Inc.
Summary of Contents for WebRelay Wireless XW-210I
Page 1: ......
