Hardware Installation
The installation procedures assume that you will be making a peer-to-peer connection between your
camera and a computer.
Make sure that the following items are available before starting the installation
：
LEO USB3.0 Area scan camera
Make sure the camera and IPC or other transmission device have normally connected via Micro
USB3.0
（
B Type
）
cable.
As applicable, a C-mount lens for the camera.
You should perform the software installation procedure first and the hardware installation
procedure second.
Steps
：
Mount C-Mount lens on the camera
Mount the camera in your test setup
Connect the camera to the computer via USB3.0 cable
LEO Series Industrial camera with USB3.0 interface
，
to ensure the transmission rate bandwidth of
Real-time image, the USB3.0 cable is required.
Following power supply modes are available
：
DC power supply: Use 6pin I/O cable
，
follow the correct instructions to connect the power
adapter
USB power supply
：
USB cable to power the camera, you need to connect the camera to the
USB3.0 interface
Driver Check
It is necessary to check whether the IPC correctly install the driver
，
which to connect to the camera.
The camera client software cannot find the camera if the driver installation failed.
Check Camera Driver
After installing the client software on the IPC and connecting the camera, the system will detect new
hardware, also to search and automatically install the hardware driver.
After the installation, you will find the new device type “VisionDatum USB3 Vision Camera” in the
system device manager.
Right-click to check whether the device driver installation correctly.