Continental Fireplaces CB30NTR, Installation And Operating Instructions Manual

Page: 57 / 84

57
EN
W415-1398 / C / 06.15.17
support. Place one pin
into the hole located allow it to
rest in the notch of the left log. on
the top of the right log.
F. Reinstall the door and
safety screen, refer to your installation
manual for installation instructions.
6.4 CHARCOAL EMBERS
Randomly place the charcoal embers along the front and sides of the log support tray in a realistic manner.
Fine dust found in the bottom of the bag should not be used.
NOTE: Charcoal embers are not to be placed on the burner.
32.1
6.5 LOGO PLACEMENT
6.6 BATTERY BACK-UP INSTALLATION
NOTE: In the event of a power failure your appliance can be operated using the battery back-up supplied.
A. Remove the safety screen by lifting it up and off of the four shoulder screws.
B. Locate your battery holder, this would have been supplied in the manual baggie.
C. Locate the red and black wires from the control module to connect to the battery holder, as shown below.
D. Connect the red wire from the control module to the red wire of the battery back-up. Ensure the
protective sleeve covers the connections, as shown below.
E. Connect the black wire from the control module to the black wire of the battery back-up. Ensure the
protective sleeve covers the connections, as shown below.
F.
Install two “D” size batteries, ensure the positive and negative ends correspond with those identified on
the holder.
G. Place the battery holder either onto the hearth, or in the front left corner of the control area, for the
duration of the power failure, as shown below.
H. Ensure the safety screen is reinstalled onto the appliance during operation.
97.1 A
Remove the backing of the logo supplied and place on the glass viewing
door, as indicated.
½"
(12.7 mm )
LOGO
½"
(12.7 mm )
E.
Place the right crossover log (W135-0579)
onto the two remaining pins.
B
A
C
D
E