Continental Fireplaces CB30NTR, Installation And Operating Instructions Manual

Page: 28 / 84

28
EN
W415-1398 / C / 06.15.17
B. Remove the contents from the firebox
and set aside, you will need the
exhaust collar from the top of the log
carton.
C. To ease assembly, remove the four
hex head screws securing the
deflector from inside the top front of
the firebox.
D. Remove the single screw from the
outer cover on the back of the
appliance.
E. Remove the four screws on the 7"
(178mm) intake collar assembly; set
the intake collar and gasket aside.
Careful not to damage gasket.
F. Remove the single screw from the
outer cover with knockout intact, on
the top of the appliance and set
aside.
G. Remove the inner cover plate and
gasket by removing the four screws.
Reinstall the inner cover plate and
gasket onto the back of the
appliance.
H. Take the outer cover (with knockout
intact) and secure onto the back of
the appliance.
I. Remove and discard the 1 1/2" thick
batt of insulation from the top
opening.
J. Place the 7" (178mm) intake collar and gasket onto the top
of the appliance and secure with the four screws.
K. Reinstall the outer cover (without knock out) over the 7"
(178mm) exhaust collar assembly and secure.
L. From inside the firebox, install the 4"
(102mm) exhaust collar up through the top of the firebox and secure with the the four hex head 3/8"
thread cutting screws. NOTE: Do not overtighten. The gasket needs only to be snug against the
firebox.