Connect Tech Blue Heat/Net User’s Manual
Revision 0.13
55
Once you have configured your Security Settings, click the
Submit
button at the bottom of the
page. A confirmation page will appear.
Figure 15: Configuring Security Settings
Configure Blue Heat/Net Settings
This section provides various Blue Heat/Net Configuration options, and shows you the saved
versus current settings. The details for each configuration option are provided below:
•
Flash Enabled
: This option enables or disables the ability of the Blue Heat/Net to boot-
up from Flash memory.
•
Bootp Enabled
: This option enables or disables the Blue Heat/Net’s ability to obtain
boot-up information from the server (see "Server IP Address" below).
•
TFTP Enabled
: This option enables or disables the ability to download and boot from a
file located on a server (see "Server IP Address" below).
•
DHCP Enabled
: This option enables or disables the use of DHCP. If DHCP is enabled,
the Blue Heat/Net will attempt to automatically obtain an IP address. If DHCP is
disabled, you must manually specify an IP address for the Blue Heat/Net.
•
Configuration Port
: This option sets the port to scan for the password to gain entry into
the Serial Configuration Manager. You can specify a particular port, or specify the
Scan
All Ports
option. In this case the Blue Heat/Net will scan all ports for the password when
the Blue Heat/Net is booting. The default setting is
Scan All Ports
.
•
Session Timeout
: This option specifies the time allowed between web page navigation.
The default session timeout is 5 minutes. This means if the Web Configuration Manager
has not received any requests for more than 5 minutes, you will be automatically logged
out. You can set the timeout from 1 minute to 2 hours, or disable the session timeout all
together by selecting the
Disable Timeout
option.
•
Boot Delay
: This option specifies time allowed for gaining access to the Serial
Configuration Manager while the Blue Heat/Net is booting. The time ranges from 2
seconds to 30 seconds. The default setting is 30 seconds.
•
Server IP Address
: This option sets the server IP address. This is used as the Server
address to use when bootp mode or TFTP mode is enabled. The default Server IP
address is 0.0.0.0
•
Blue Heat/Net IP Address
: This option sets the IP address of your Blue Heat/Net. The
default IP address for your Blue Heat/Net is 192.168.42.1