Connect Tech Blue Heat/Net User’s Manual
56 Revision 0.13
•
Domain Name
:
This option sets the domain name of your Blue Heat/Net. The default
domain name is
blueheat.net
.
•
Host Name
:
This option sets the hostname of your Blue Heat/Net. The default hostname
is BHNssssss, where ssssss is your Blue Heat/Net serial number.
•
Gateway IP Address
:
This option sets the Gateway IP address for your Blue Heat/Net.
The default Gateway IP address is 0.0.0.0
•
Broadcast IP Address:
This option sets the Broadcast IP address. The default Broadcast
IP address is 255.255.255.255.
•
Subnet Mask
:
This option sets the Subnet mask IP address. The default Subnet mask IP
address is 255.255.255.0.
•
Bootfile Name
:
This option specifies the default file name which will be used for Blue
Heat/Net boot-up,
if TFTP is enabled
. If TFTP is enabled, the Blue Heat/Net will
attempt to download the bootfile you specify from a Server IP address you specify (see
"Server IP Address" above). The bootfile name should reference a valid uClinux kernel
image. If TFTP is enabled, the Blue Heat/Net unit will attempt to download this image,
and will also attempt to decompress the image and run it.
•
TCP Port:
This option allows you to change the starting local TCP port that is used to
service clients connecting to the Blue Heat/Net unit. The default TCP port is 49152.
When altering the TCP port on the Blue Heat/Net unit, you must also alter it on the
user’s side.
•
Domain Server IP Address:
This option sets the Domain Name Server IP address. The
default DNS IP address is 0.0.0.0.
After you've made any necessary configuration changes, click the
Submit
button at the bottom of
the page. A confirmation page will show up confirming the Blue Heat/Net changes.
Figure 16: Configuring Blue Heat/Net Settings
Configure Firmware
This section enables you to download new firmware to the Blue Heat/Net unit. Select a
download source and a specific firmware file path, if applicable, and then submit the download
request. This section also provides a link to reboot your Blue Heat/Net. This is standard
procedure after installing new firmware.
