Connect Tech Blue Heat/Net User’s Manual
36 Revision 0.13
Syntax:
port [port#]
[line_mode= | lmode=]
[baudrate= | baud=]
[data_bits= | bits=]
[parity= | par=]
[stop_bits= | stop=]
[software_flow= | sflow=]
[xoff=]
[xon=]
[hardware_flow= | hflow=]
[local_loopback= | llb=]
[special_char_mode= | scm=]
[error_char= | errch=]
[break_char= | brkch=]
[event_char= | evtch=]
[use_xoff_xon_limits= | xlim=]
[xofflim=]
[xonlim=]
[escape_char= | esc=]
[fifos=]
[txload=]
Description: This command establishes the initial settings of the serial ports when the Blue
Heat/Net is powered up.
Options:
port#
This specifies the port number to change or query. If the port number is omitted,
the command returns a summary of all the ports on the Blue Heat/Net.
N
where N is 1 to the number of ports on the unit.
line_mode= | lmode=
This is used to change the Line Interface Mode settings on units supporting this
feature.
232
Sets RS-232 mode
full
Sets RS-422/485 Full-Duplex mode
4wire
Sets RS-422/485 4-Wire Multi-drop mode
2wire
Sets RS-422/485 2-wire Multi-drop mode (½ Duplex)
±tri
Enables or disables line driver Tri-State at power-up. (Valid
only with RS-422/485 Full Duplex mode.)
±bt
Enables or disables Line Bias and Termination on RS-485
ports
baudrate= | baud=
This sets the baud rate.
50
to
460800
(default
9600,
maximum 230400 baud on RJ-45 models )
data_bits= | bits=
This sets the number of data bits in each character (byte).
5, 6, 7
or
8
(default)
parity= | par=
This sets the parity mode
n
no parity (default)
e
even
o
odd
0
force 0 (space parity)
1
force 1 (mark parity)
