Hornington WHR-HP-G300N, Quick Start Manual

Page: 1 / 8

WHR-HP-G300N Router Settings (For: Pccw, HGC PPPoE User)
Last Updated 28/11/2009 Hornington KB: http://kb.hornington.com WHR-HP-G300N PPPoE Settings Page 1
4. Please connect your broadband service with a network cable (or from
Hardware Setup of WHR-HP-G300N Router: cable modem) to the “ INTERNET ” port on the ROUTER. Then use
another network cable to connect “ LAN1 ” port on the ROUTER to the
1. Set Router switch to “ ON ”. Ethernet adapter on your PC. Make sure indicators “ INTERNET ” and
“ LAN1 ” near lan ports are ON .
2. Power on Buffalo Router, and wait for 2 minutes.
The “ Power ”, “ Wireless ” and “ Router ” indicators will be ON , and
“ DIAG ” will be OFF .
3.
To reset the router, please insert “RESET” hole by a paper clip for about
10 seconds, and wait for 2 minutes. The “ Power ”, “ Wireless ” and
“ Router ” indicators will be ON , and “ DIAG ” will be OFF .
5. For i-cable user, please power off modem for 1 hour . Then power on
modem again.
. Wait for 2 minutes.