ConMed 1000 SES, Service Manual

Page: 20 / 26

6-2
nents which may point to the source of the prob-
lem. Verify that all connections are clean and seat-
ed properly and that all harness connections are
sound and not shorting. Check the power cord
and all other wiring for evidence of mechanical
damage. Check the mains voltage against the
nameplate on the back of the unit. Operating the unit at the wrong mains voltage will cause mal-
functions. Check that all mechanical connections
are secure.
See Troubleshooting Chart below.
Problem Potential Cause Corrective Action
1. CONMED 1000 SES 1. Filter not seated completely. 1. Reinstall filter, press firmly into
is operational, but suction is place.
minimal or none.
2. Filter clogged. 2. Replace filter.
3. Vacuum hose clogged. 3. Check or replace hose.
4. Motor/Blower obstructed. 4. Contact CONMED Technical
Services.
2. CONMED 1000 SES 1. Not plugged into electrical 1. Check power outlet or check to
does not function, although outlet or system not powered be sure system is powered up with
“ON” button is pressed. up with switch. switch on rear of unit.
2. Circuit breaker(s) tripped. 2. Reset circuit breaker(s) on rear
of unit.
3. Footswitch/Remote Switch 3. Unplug footswitch or remote
is plugged into unit. switch.
4. Electronic system failure. 4. Contact CONMED Technical
Services.
3. “Service” light is illuminated. 1. Motor/Blower requires servicing. 1. Replace motor brushes per
Section 6.6.4 or contact CONMED
Technical Services.
4. Motor/Blower operates 1. Incorrect power to system. 1. Check power outlet to ensure
intermittently. proper power is supplied to system.
2. Electronic system failure. 2. Contact CONMED Technical
Services.
60-6852-ENG (-).qxd 2/1/99 12:40 PM Page 6-2