Installation Instructions
Positioning module
Conductor rail program 0832, C-rail,
Console, ProShell
MV0800-0015a-EN
www.conductix.com
translated document
Page 8 of 23
Pre-drill the positioning band profile on both sides as shown in the illustration and then screw it to the tensioning unit.
Fig.10: Installation variant 1 or 2
Fig. 11: Installation variant 3
The holding plates are screwed to the support profile depending on the intended position (for installation variants, see table in chapter
2.2.1). The tensioning units are connected to the holding plates in order to tension the positioning band profile in a straight line.
