Installation Instructions
Positioning module
Conductor rail program 0832, C-rail,
Console, ProShell
MV0800-0015a-EN
www.conductix.com
translated document
Page 17 of 23
5.2.2
Inserting/clipping the positioning band profile into the band holders
CAUTION!
Danger of cutting!
The following activities may result in injury due to cutting due to carelessness.
Wear suitable protective clothing such as gloves and work safety shoes.
The positioning band roller profile can "spring open" when unlocking. Avoid danger of injury
when unlocking the positioning band roller profile!
CAUTION!
Make sure that the positioning band profile is correctly aligned in the lane!
Before inserting/clipping in the positioning band profile, check the alignment of the positioning band
in the lane!
If necessary, turn the positioning band in the lane: The positioning band must be aligned
with the reader and the start code must be on the correct side of the aisle (see chapter 6.3)
Fig. 29: Clip in the positioning band profile (band holder is attached at the
top)
Fig. 30: Clip in the positioning band profile (band holder is attached at the
bottom)
If the band holder has been clipped in at the bottom of
the support profile, the positioning band profile must not
be clipped in from the top. This leads to a deformation of
the lower clip of the band holder.
The positioning band profile must be clipped in from the
bottom.
After installation of the band holders and the positioning band profile, the positioning band profile must be easily and freely movable
in the X direction in order to be able to set the desired positioning range and to avoid displacement when the temperature changes.