Installation Instructions
Positioning module
Conductor rail program 0832, C-rail,
Console, ProShell
MV0800-0015a-EN
www.conductix.com
translated document
Page 13 of 23
4.2.1.1
Installation onto console
Screw the band holder to the Console (DIN 912 cheese head screw, square nut):
Fig. 20: Aligning the band holder
Fig. 21: Screwing on the band holder
Fig. 22: Band holder screwed onto the console
4.2.2
Inserting/clipping the positioning band profile into the band holders
CAUTION!
Danger of cutting!
The following activities may result in injury due to cutting due to carelessness.
Wear suitable protective clothing such as gloves and work safety shoes.
The positioning band roller profile can "spring open" when unlocking. Avoid danger of injury
when unlocking the positioning band roller profile!
CAUTION!
Make sure that the positioning band profile is correctly aligned in the lane!
Before inserting/clipping in the positioning band profile, check the alignment of the positioning band
in the lane!
If necessary, turn the positioning band in the lane: The positioning band must be aligned
with the reader and the start code must be on the correct side of the aisle (see chapter
6.3)
